Slow transformation

Added by Wim Looijen over 1 year ago

Dear all,

We made a alignment mapping and replaced the source data with newer source data.
After that we modified the alignment mapping but the resulting transformation is suddenly very slow.

After restarting HALE the transformation was as fast as before.

Can we circumvent this?

Best Regards,

Wim Looijen


Replies (5)

RE: Slow transformation - Added by Thorsten Reitz over 1 year ago

Hi Wim,

That doesn't sound like typical behavior, but we'd need the data + project to investigate :). On what operating system do you use hale?

All the best,

Thorsten

RE: Slow transformation - Added by Wim Looijen over 1 year ago

Hi Thorsten,

The data are bigger than 5Mb so I cannot send them this way. The project is attached.

Cheers,
Wim

RE: Slow transformation - Added by Wim Looijen over 1 year ago

Hi Thorsten,

The OS used is Windows 7 Enterprise.

Cheers,
Wim

RE: Slow transformation - Added by Thorsten Reitz over 1 year ago

Hi Wim,

Thanks for the project. I checked it, it is really straight forward, there is nothing obvious that would cause hale to go slow. Did you encounter this issue again?

All the best,

Thorsten

p.s.: did you receive our mail with the offer?

RE: Slow transformation - Added by Wim Looijen over 1 year ago

Hi Thorsten,

We have not encountered the problem but haven't done this kind of exercise again.
We will try to test this week to simulate the same event.

Cheers,
Wim

(1-5/5)